Meyer's VB750 - Page 8

MODEL: VB750 Page 8
DECAL J. PART NO. SW2001
DECAL K. PART NO. SW2000
DECAL M. REFLEC-
TIVE TAPE-RED
PART NO. PM17-5915
DECAL L. REFLEC-
TIVE TAPE-YELLOW
PART NO. PM17-5910
CAUTION: IF ANY SAFETY SIGN BECOMES UNREADABLE FOR ANY REASON, THE SIGN MUST BE
REPLACED WITH A NEW SIGN. IF THE SPREADER IS REPAINTED, ALL SAFETY SIGNS MUST BE RE
-
PLACED. CONTACT YOUR DEALER OR MEYER’S EQUIPMENT MANUFACTURING CORP. IF YOU RE
-
QUIRE ANY SHIELD OR SIGNS FOR REPLACEMENT.
SAFETY SIGNS
START UP PROCEDURE
1. Make certain everyone is clear of machine before starting
engine or operation.
2. Turn Flow Control to Slowest Position.
3. Engage P.T.O.
4. RAISE END GATE.
5. Engage Tractor Hydraulic Lever to Full Flow Position.
6. Start Apron by Rotating Flow Control Dial Clockwise.
DECAL O. PART NO. 3011
DECAL T.
PART NO. VB105
DECAL P. PART NO. VB101
DECAL Q. PART NO. VB102
DECAL R.
PART NO. VB103
DECAL S.
PART NO. VB104
DECAL U.
PART NO. VB106
DECAL V.
PART NO. 3014