CHAPTER 5: QUICKFLY RIGGING
34
MYA-MINA MOUNTING YOKE
The MYA-MINA mounting yoke flies up to three MINA loud-
speakers from a single hanging point using a C-clamp or
equivalent. The yoke includes two bracketing options: the
MPA-2 for attaching to two cabinets, and the MPA-3 for
attaching to one or three cabinets. The brackets bolt directly
to the M6 threads in the end frames for one of the cabinets.
For flown applications, the yoke supports up to 30 degrees
of uptilt and severe downtilts of up to 90 degrees. For flying
larger arrays, the MG-MINA grid is recommended; for
smaller profile applications, the MUB-MINA U-bracket is
recommended.
NOTE: For complete information on configura-
tion and load ratings for the MYA-MINA, as
well as for other rigging accessories, refer to the
MG-MINA Assembly Guide (PN 05.207.101.01) avail-
able at www.meyersound.com
.
CAUTION: The MYA-MINA’s mounting bracket
at the top of yoke has one 1/2-inch center hole
that is rated for flown applications. The smaller two
center holes and four corner holes should only be
used for attaching to pole-mount adapters.
MYA-MINA with MPA-3 Adapter and Three MINAs
MYA-MINA with MPA-3 Adapter, Three MINAs, and C-clamp
To Next Page
Loading...
Need help?
General
