RMS USER GUIDE
13
2. Connect your computer's Ethernet directly to RMServer.
3. Set your computer to a static IP address in the network
range 192.168.0.x.
4. Open your browser and point it to 192.168.0.120, the
default address of RMServer. The login page will appear.
TIP: If any of these methods appears to hang
up, try clicking in the URL address bar of the
browser and pressing Enter to reapply the URL
request.
Setting an IPv4 Address for RMServer
Figure 6: The Host and Network Information area of the Basic Settings
tab holds IPv4 settings.
In order for users employing IPv4 to communicate with
RMServer, the computer, router, and RMServer all need to
be set to the same IP network range. To set RMServer's
IPv4 address:
1. Login to RMServer's web server page.
2. Go to the Basic Settings tab.
3. In the Network Information area, confirm that the Config-
ure field is set to Manually.
4. In the Network Information area, change the Static IP
Address field to an address with the network range you
want to use.
5. Enter the proper Subnet Mask and Gateway settings.
The default subnet mask is 255.255.255.0, the default
gateway address is 192.168.0.1.
6. Click the Save Settings button at the bottom of the win-
dow.
7. A dialog will appear saying that restart is required. Click
the Restart Now button to restart RMServer.
8. Change your computer (and router, if present) IP address
to the same network range as RMServer.
9. Test the connection by pinging RMServer with the ping
command in a terminal.
Settings
The Dashboard tab displays current settings. Settings are
adjusted in the Basic and Advanced Settings tabs.
Settings groups on the Basic and Advanced Settings pages
can be expanded or collapsed by clicking on the disclosure
triangle to the left of the settings group name.
Dashboard
The Dashboard tab displays setup parameters for
RMServer, but editing of parameters is done on the Basic
and Advanced Settings pages.
To Next Page
Loading...
