GB
CS 300 Gate Controls / rev. 04.06 – 11
7.2 LCD monitor, modes of operation7.2 LCD monitor, modes of operation
The control has four modes of operation with the
LCD monitor:
1. AUTOMATIC
2. ADJUSTMENT
3. INPUT
4. DIAGNOSIS
When the jumper H is pulled, the + button,
the - button and the P button have no function.
The display still functions.
Operating mode 1: AUTOMATIC
In the AUTOMATIC operating mode the door system
is operated.
Display:
- displays the function being carried out
- displays any error messages
If the “self locking“ parameter is set to OFF in the
input menu, the display changes from AUTOMATIC
to MANUAL OPERATION.
Operating mode 2: ADJUSTMENT
In the ADJUSTMENT mode, the OPEN/CLOSED end
position settings are adjusted.
Warning! Warning!
In the ADJUSTMENT mode of
operation, the drive does not switch off
when the end position is reached.
The door can be damaged if driven
beyond the end position.
Fine adjustments can be made in the INPUT
operating mode.
Display:
- displays the end position value
Operating mode 3: INPUT
In the INPUT operating mode, the values of various
parameters can be altered.
Display:
- displays the selected parameter
- displays the programmed value /status
Operating mode 4: DIAGNOSIS
In the DIAGNOSIS operating mode, door-specifi c
checks can be queried.
Display
- displays the check
- displays the checking status
To Next Page
Loading...