Transportation and storage
51
Problem Possible cause Recommended action
Error messages
appear when the
control software
runs.
z
The parameters
are not set
properly.
z
Errors occur
when the
software
communicates
with hardware.
1. Perform a self-test in the
maintenance interface.
Check the record of the
hardware that fails the self-
test.
2. Check error messages
in the log, and solve the
problem according to on-
screen instructions.
3. Restart the device.
4. If the problem persists,
contact the technical
support.
Temperature error
message and
warning appears
in the sequencing
interface.
z
The temperature
exceeds the
preset limits.
z
Temperature
sensor error.
Record the warning and logs
of this run and contact the
technical support.
Waste level sensor
alarms.
z
The waste level
exceeds the
preset limits.
z
The level sensor
is not installed
properly.
z
The level sensor
is damaged.
Record the warning and logs
of this run and contact the
technical support.
Transportation and storage
z
For information about the environmental requirements for storing
the device, refer to
Specifications on Page 55
.
z
If you want to move or transport the device, contact the technical
support.
To Next Page
Loading...