To Next PageTo Next Page
Need help?Do you have a question about the Mhouse RC2 and is the answer not in the manual?
Details on connecting the main power supply to the receiver.
Instructions for connecting the equipment to be controlled by the receiver.
Procedure to check if transmitters have been previously memorized in the receiver.
Simplified memorization mode where transmitter keys are pre-set by the receiver.
Advanced memorization mode allowing specific command configuration for each transmitter key.
Memorize a new transmitter to operate identically to a previously memorized one.
Procedure to program the two independent timers for automatic relay deactivation.
Instructions on how to clear the receiver's stored memory for transmitters and timers.
General