What’s Required?
● #1 Phillips Screwdriver
● Cutting tool - such as scissors or diagonal cutter
● 1.5 mm hex wrench
● 2 mm hex wrench
● 2.5 mm hex wrench
Notes: Tools included in your kit may vary depending on the drone model selected when kit
was purchased.
Let’s get started!
Warning: Installation of this kit into a drone should be done by an experienced person, in
adherence with all recommendations and guidelines of the drone manufacturer. Before
assembling this kit, ensure the drone is not powered, has the battery removed, and the
rotor blades removed. Failure to follow these instructions can result in injury, death
and/or damage to the drone, or RedEdge-M/MX/MX Blue sensors.
MicaSense recommends checking all fasteners periodically and tightening as needed.
Both the RedEdge-MX and RedEdge-MX Blue need to be updated to the latest firmware.
The system will not operate if the firmware versions do not match. You can find the latest
firmware available at https://www.micasense.com/firmware-updates
Rev 01 - March 2020
PAGE 4
To Next Page
Loading...