MicaSense RedEdge User Manual

PAGE 4
Attaching the power board
1. Remove the GoPro mount pin.
GoPro mount pin removed.
2. Using the three 4-40 screws, attach the RedEdge/GoPro adapter assembly to the RedEdge with a
#1 drive phillips screwdriver.
Three at head screws tightened to the
RedEdge.
3. Slip the adapter assembly into the GoPro mount on the Solo.
Adapter assembly placed in Solo GoPro mount.

MicaSense RedEdge Specifications

General

Spectral Bands	Blue, Green, Red, Red Edge, NIR
Band Central Wavelength	Blue: 475nm, Green: 560nm, Red: 668nm, Red Edge: 717nm, Near Infrared: 840nm
Bandwidth	Blue: 20 nm, Green: 20 nm, Red: 10 nm, Red Edge: 10 nm
Image Resolution	1280 x 960 pixels per band
Capture Rate	1 capture per second
Field of View	47.2° HFOV
Power Requirements	7-25 V DC
Sensor	5 individual sensors
Interfaces	Serial, Ethernet
Operating Temperature	0-50° C
Storage Temperature	-20-60° C
DLS	Integrated Downwelling Light Sensor (DLS)
Sensor Type	Global Shutter CMOS