Miccus BBRTX-01 - Receive (RX mode); Volume Control; Automatic Reconnection; Factory Reset Procedure

7
Receive(RXmode):
1. Power on the RTX: press and hold the power buon (3 seconds)
unl the indicator light begins ashing.
2. Press and hold the RX buon 3 seconds and release; the light will
ash red and blue indicang it is in pairing mode.
3. Open the Bluetooth® menu on your phone or tablet and select the
Home RTX. If a passkey is required, use “0000”.
4. WAIT for the devices to connect. This may take up to a minute.
5. When pairing is complete, the RTX light will be a solid blue.
6. To begin streaming wireless audio, simply press play on your audio
source, adjust the volume to preference, and enjoy!
Volume:
Bluetooth® devices are designed to send or receive an audio signal, but
are passive with no volume control. Volume level must be adjusted via
the audio input or output source connected to the Home RTX.
Reconnecon
Now that the Home RTX is paired, if le connected to USB power, the
Home RTX will automacally reconnect to the last paired device when
within range.
Factory Reset
To reset pairing memory, simply unplug the Home RTX from USB power
for 20 seconds. The Home RTX remembers only one device pairing at a
me, and once it is disconnected from power it will clear the pairing
from memory.