Miccus BBRTX-01 - Pairing the Home RTX with another Device

6
PairingtheHomeRTXwithanotherDevice
The pairing process creates a Bluetooth® bridge between a Bluetooth®
transmier and a Bluetooth® receiver. The versale Home RTX can
funcon as either a Bluetooth® transmier OR receiver. The pairing
process should take approximately 5-10 minutes.
For quicker, easier pairing:
• Verify the RTX has power and audio connecons completed
• Make sure the RTX and your Bluetooth® device are physically
located near each other during the pairing process, no more
than 3 apart.
• Make sure any previously paired device, Bluetooth®
headphones, speakers, adaptors are turned o so the RTX is
ready to look for a NEW device to pair to.
• Please follow the below steps in a mely manner, without
interrupons for best results.
TransmitMode(TX):
1. Power on and start the pairing mode on your receiving device,
i.e. Bluetooth® enabled headphones, speaker or other compa-
ble A2DP Bluetooth® prole device.
2. Power on the Home RTX: press and hold the power buon
(3 seconds) unl the indicator light begins ashing.
3. Press and hold the RX buon for 3 seconds and release; the
light will ash red and blue indicang it is in pairing mode.
4. Double Press the TX buon (2 clicks) the red and blue indicator
light is briey interrupted, then ashes red and blue again
indicang it is in pairing mode.
5. WAIT for the devices to connect. This may take up to a minute.
6. When pairing is complete, the RTX light will be solid red.
7. To begin streaming wireless audio, simply press play on your
audio source, adjust the volume to preference and enjoy!