Miccus BBRTX-01 - Quick Start Guide; Pairing; Use as a transmitter (TX Mode); Use as a receiver (RX Mode)

Quick Start Guide:
• Aachtheantenna:On the back of the RTX, remove the red
rubber connector cover and aach the antenna. Turn clockwise
unl slightly snug. Posion the antenna upright.
• Connecttheaudio:Before powering up, choose the included
connector cable that is appropriate for your connecon. When
using as a transmier (TX mode) connect your audio cable to
the “TX Audio In” (RCA) or to the “Line In” (3.5mm). When
using as a receiver (RX mode) connect your audio cable to the
“RX Audio Out” or to the “Line Out”. Some devices may require
an addional audio adapter or cable which is not included.
• Poweron/o:Connect to USB power and hold the power buon
(the front center buon) for 3 seconds unl the indicator light
turns on and begins blinking. To power o, hold the power buon
for 3 seconds unl the indicator light turns o.
Pairing:
1. Useasatransmier(TXMode)
• Place your Bluetooth® receiving device into pairing mode.
• Power on the Home RTX, press the RX buon once for 3
seconds, release, and then double press the TX buon.
• Allow up to 30 seconds, when pairing is successful the RTX
indicator light turns solid red.
2. Useasareceiver(RXMode)
• Power on the Home RTX, press the RX buon for 3 seconds and
release.
• Open the Bluetooth® menu on your phone or tablet and select
the Home RTX.
• If required, use passkey “0000”. When pairing is successful the
RTX indicator light turns solid blue.
1