MICODUS MV55G - Page 8

Functions Command Format Explanation
Version Inquiry
Parameter Inquiry
VERSION#
PARAM#
Status Inquiry STATUS#
BATTERY: XX% (Built-in Battery Power Percent)
INTERNET: CLOSED (No Network) FAILED (Conn-
ecting Network or Failure) SUCCESS (Connected
to Network）
NET: NONE (No GSM Signal),HIGH / MED /
LOW (Signal Strength)
GPS: CLOSED (GPS Module Closed) , FIXED,
N (Positioned and satellite number), UNFIX,
0 (Not Positioned yet)
SPEED:30KM/H
ACC: ON / OFF (ACC on or off)
POWER: CONNECTED / DISCONNECTED (Power
Connected or Disconnected), 12.5V (Vehicle
battery voltage)
SENSOR: ON/OFF (Sensor on or off), LEVEL:
3 (Sensitivity level 1-9)
FORTIFIED STATE: ARM (Arm or Disarm)
Latitude&Longitude
Inquiry
Map URL Inquiry URL#
WHERE#
Time Zone Setting
Set the angle upload
GMT,Time zone orientation,
Whole Time Zone[,Half Time Zone]#
ANGLEREP,[X][,A][,B]#
ANGLEREP,OFF#
GMT,E,8# (if no half time zone)
GMT,W,9,30# (if has half time zone)
NOTE: Parameter : E / W；0 ~ 12; 0/15/30/45
Query current mileage
CENTER,A,13800138000#
NOTE: Center number is only used for cutting off
power & oil, it can only be set by SOS Administrator
when using this command by SMS.
X=ON/OFF, default：ON; A=5～180 degrees,
diversion angle degree, default：30 degrees；
B=2～5 seconds, detecting time, default：3 seconds,
NOTE: Reply message’s language is determined by
device’s language setting, if get position content
failed, device will reply Google Map location link.
Address Inquiry POSITION#
Mileage Statistics
Add Center Number
MILEAGE,[A],[B]#
MIELEAGE#
CENTER,A,center number#
A=ON/OFF, On/Off mileage calculation, default: Off
B=0～999999，Mileage initial value , unit：km ;
default: 0, mileage return to zero