MICODUS MV720 - Functions Explanation

5. Functions Explanation
* Set admin number by this sms command:
admin123456+space+mobile number with country code
* Send this sms command from the admin number to cut
off fuel:555
* If the network signal and satellite signal both are available, when the equipment speed
exceeds 20km/h, the fuel circuit will not be cut off immediately, it will cut off intermittently
till the speed is below 20km/h, then just can be completely cut off.
* In the tracker has network signal and but no satellite signal, the fuel circuit will be cut
off intermittently, after 2, 3 minutes it will be cut off completely;
* If the tracker stopped more than 5 minutes, the fuel circuit will be cut off immediately,
and then connected, but if you vibrate the tracker or vibrate the tracker the fuel cirsuit will
be cut off immediately;
a. Vibration Alert:
This vibration alert function just work under stationary
status. How to use this function:
b. Cut Off Fuel/Resume Fuel
* Enable the device to enter into arm mode by this
sms command:
111
* Conifgure the alarm ways by this sms command:
vibalm123456
* Set admin number by this sms command:
admin123456+space+mobile number with country code
* Keep the device under stationary status more than 5min to let it enter into sleep arm mode;
* Vibrate the device then the tracker will send the vibration alarm messages
For example:
admin123456 0086134********
admin ok
cut oil ok
MV720
555
For example:
admin123456 0086134********
admin ok
arm ok
MV720
111
vibrate sms alarm set ok
vibalm123456
Please follow with the quick user guide carefully!
:About the cut off fuel function, firstly please
make sure the fuel circuit is connecting to main power. Secondly,
it has 3 different performance, please read it carefully:
NOTE