MICODUS MV730 - Cut Off Fuel;Resume Fuel; Engine On;Off Alarm

* Set admin number by this sms command:
admin123456+space+mobile number with country code
* Send this sms command from the admin number to cut
off fuel:555
* If the network signal and satellite signal both are available, when the equipment speed
exceeds 20km/h, the fuel circuit will not be cut off immediately, it will cut off intermittently
till the speed is below 20km/h, then just can be completely cut off.
* In the tracker has network signal and but no satellite signal, the fuel circuit will be cut
off intermittently, after 2, 3 minutes it will be cut off completely;
* If the tracker stopped more than 5 minutes, the fuel circuit will be cut off immediately,
and then connected, but if you vibrate the tracker or vibrate the tracker the fuel cirsuit will
be cut off immediately;
b. Cut Off Fuel/Resume Fuel
* Keep the device under stationary status more than 5min to let it enter into sleep arm mode;
* Vibrate the device then the tracker will send the vibration alarm messages
For example:
admin123456 0086134********
admin ok
cut oil ok
MV730
555
:About the cut off fuel function, firstly please
make sure the fuel circuit is connecting to main power. Secondly,
it has 3 different performance, please read it carefully:
NOTE
* Set admin number by this sms command:
admin123456+space+mobile number with country code
* Configure the alarm ways via this sms command:
autorep123456,AB
A=0 (Engine ON: No Alarm);
A=1 (Engine ON: SMS only);
A=2 (Engine ON:Platform only);
A=3 (Engine ON: SMS+Platform)
B=0 (Engine OFF: No Alarm);
B=1 (Engine OFF: SMS only);
B=2 (Engine OFF: Platform only);
B=3 (Engine OFF: SMS+Platform)
c. Engine On/Off Alarm
For example:
admin123456 0086134********
admin ok
set ok
MV730
autorep12346,12