3
©2018 Micro-Air Rev 1.01
Making a good crimp
Good crimps are essential for a long-lasting, reliable installation. There are many informative
guides, videos and tool recommendations on the internet. Please consult this excellent reference if you
are unfamiliar with crimping connectors or need to purchase a tool.
Moderately tug on the crimp joint after making your crimp to be sure the joint was properly
made. If the wire pulls out, the joint was not done correctly and must be redone. It is better to test
every joint during the install than to find out on a hot day that the crimp failed!
Installation kit for Coleman Mach (KIT-364-CM1)
(Note some of the items in this kit are meant for use in the Coleman low-profile systems as well, and will
therefore not be used in this described installation.)
1. End Splice
2. Wire Ties
3. Yellow female quick-connect (ES WHITE
wire)
4. Male quick-connect
5. Piggy-back quick-connect
6. Blue female quick connect (ES ORANGE
wire)
7. Double sided mounting tape
To Next Page
Loading...
