VP-ITC MicroCalorimeter User’s Manual
• Carefully insert the pipette into the sample cell access tube.
Watch the end paddle of the long needle to insure it is inserted directly into the access hole,
hold the pipette vertical and slowly lower the pipette. When the pipette is almost completely
inserted you may have to push down slightly to compensate for the resistance of the rubber
o’ring to seat the pipette.
Enter the Run Parameters into VPViewer
• Select the Load Run File button from the main window buttons.
.
• Select the water.inj run parameters file and click Open.
The ITC Controls window will show run parameters for the water experiment.
54
To Next Page
Loading...