Microchip Technology dsPIC33CK - Page 14

dsPIC33CK Low-Voltage Motor Control Board User’s Guide
DS50002927A-page 14  2020 Microchip Technology Inc.
FIGURE 2-1: CONNECTORS – dsPIC33CK LOW-VOLTAGE MOTOR CONTROL BOARD
TABLE 2-1: MOTOR CONTROL BOARD CONNECTORS
Connector
Designator
No. of
Pins
Status Description
J1 3 Populated Input DC power supply jack
J2 2 Populated Input DC power supply – two-pin terminal connector (5 mm pitch,12-30 AWG wire insert)
J3 6 Not Populated UART interface connections
J4 2 Not Populated Erase jumper – used to switch PICkit™ On-Board (PKOB)
programmer/debugger to Boot Recovery mode through MPLAB
®
X IDE
J6 5 Populated USB Micro-B connector for establishing the serial interface with the host PC
J7 6 Populated Hall sensor interface terminal connector (2.54 mm pitch, 20-30 AWG wire insert)
J8 6 Populated Quadrature Encoder Interface terminal connector (2.54 mm pitch,
20-30 AWG wire insert)
J9 2 Not Populated External temperature sensor (thermistor) interface connector (2.5 mm pitch)
J10 6 Not Populated ICSP™ header – interfacing programming/debugging the dsPIC
®
DSC
J11 16 Populated mikroBUS™ socket for interfacing a Click Board™ with the Motor Control Board,
labeled as ‘A’ on the board
J12 16 Populated mikroBUS socket for interfacing a Click Board with the Motor Control Board, labeled
as ‘B’ on the board
J13 5 Populated PICkit On-Board (PKOB) programmer/debugger interface connector (standard
female USB Micro-B connector)
J14 3 Populated Three-phase inverter output for connecting motor (5 mm pitch,
12-30 AWG wire insert)
J16 2 Not Populated Jumper (2.54 mm pitch) which may be optionally used to connect the positive supply
(V
DC ) input of connectors, J1 and J2; shorted by default on the board using PCB trace
J13
J10
J6
J3
J4
J11
J12
J9
J7
J8
J14
J16
J1
J2