Microchip Technology IS2083 Series - User Manual

IS2083
IS2083 SDK Debugger User's Guide
Introduction
This document describes how to use the SEGGER JLINK debugger to enable software debugging of 8051 MCU core
that is part of the IS2083BM. The SEGGER debugger makes use of IS2083BM 2-wire JTAG interface to download
8051 firmware images into IS2083BM SQI flash. It then controls the IS2083BM SQI CPU register to provide
debugging features. The following chapters describe the software and hardware prerequisites, setup and procedure
to enter the Debugging mode.
© 2019 Microchip Technology Inc.
User Guide
DS50002892A-page 1

Summary

Introduction to IS2083 SDK Debugger

IS2083 Quick References

Reference Documentation

Lists official documents and websites for IS2083 and BM83.

Software Prerequisites

Details required SDK, tools, and license validity for debugging.

Hardware Prerequisites

Lists necessary hardware components like J-Link debug probes.

IS2083 Software Setup Guide

Keil µVision Setup

Step-by-step configuration of Keil µVision for debugging the IS2083BM.

SDK Settings

Configuration steps for SDK projects to enable debugging features.

IS2083 Hardware Connection

J-Link Probes Connection

Details on connecting J-Link debug probes to the BM83 EVB.

Application Board Connection

Pin details for connecting J-Link to the IS2083BM/BM83 board.

IS2083 Start Debugging

Enabling Debug Mode

Procedure to enable debug mode and start the debugging session in Keil µVision.

IS2083 Document Revision History

Microchip Technology IS2083 Series Specifications