IS2083
IS2083 SDK Debugger User's Guide
Introduction
This document describes how to use the SEGGER JLINK debugger to enable software debugging of 8051 MCU core
that is part of the IS2083BM. The SEGGER debugger makes use of IS2083BM 2-wire JTAG interface to download
8051 firmware images into IS2083BM SQI flash. It then controls the IS2083BM SQI CPU register to provide
debugging features. The following chapters describe the software and hardware prerequisites, setup and procedure
to enter the Debugging mode.
© 2019 Microchip Technology Inc.
User Guide
DS50002892A-page 1
To Next Page
Need help?
General
