2021 Microchip Technology Inc. DS00003118C-Page 97
AN3118
APPENDIX R: MCU DFU
R.1 Rehex BM83
Perform the following steps to rehex the BM83 image
using the isUpdate Tool:
1. Start isupdate.exe
2. Click on Browse and choose MCU, DSP, and
Config settings or any combination of the three.
It is recommended that the image number reflect
the combination.
3. Click on Rehex and provide the output file name
and click on Apply as shown the following fig-
ure.
- The green status bar in the following figure
indicates the progress of conversion.
4. Once it is combined successfully, a log console
will display the Convert Success message as
shown in the following figure.
To Next Page
Loading...
