Microchip Technology RN4870 - Page 18

RN4870/71 Bluetooth
®
Low Energy Module User’s Guide
DS50002466A-page 18  2016 Microchip Technology Inc.
2.4.6 SB,<H8>
This command sets the baud rate of the UART communication. The input parameter is
an 8-bit hex value in the range of 00 to 0B, representing baud rate from 2400 to 921K,
as shown in Tab le 2- 3.
2.4.7
SC,<0-2>
This command configures the beacon feature. It expects one single digit input param-
eter as described in Tab le 2- 4 .
Refer to commands IB (2.6.20) and NB (2.6.21) to configure beacon payload.
TABLE 2-3: UART BAUD RATE SETTINGS
Setting Baud Rate
00 921600
01 460800
02 230400
03 115200
04 57600
05 38400
06 28800
07 19200
08 14400
09 9600
0A 4800
0B 2400
Default: 03
Example: SB,07 // Set the UART baud rate to be 19200
Response: AOK
ERR
// Success
// Syntax error or invalid parameter
TABLE 2-4: BEACON MODE SETTINGS
Setting Beacon Mode
0 Beacon feature is disabled
1 Beacon feature is enabled; connectable advertisement is dis-
abled
2 Non-connectable beacon and connectable advertisement are
both enabled.
Default: 0
Example: SC,2 // Enable both beacon and advertisement
Response: AOK
ERR
// Success
// Syntax error or invalid parameter