Need help?Do you have a question about the Microchip Technology PICkit 2 and is the answer not in the manual?
General| Brand | Microchip Technology |
|---|---|
| Model | PICkit 2 |
| Category | Motherboard |
| Language | English |
Provides an overview of the PICkit 2, its contents, and key features.
Introduces the PICkit 2 as a low-cost development programmer for Microchip Flash microcontrollers.
Details the physical overview of the PICkit 2 programmer, including its components like USB, LEDs, and connectors.
Introduces the PICkit 2 Programming Software and its interface, including menu bar and key windows.
Provides an introduction to the PICkit 2 for programming MCUs and covers the software installation process.
Explains how to select the correct device family and how the programmer identifies the target MCU.
Details powering the target device and importing compiled HEX files into the software.
Describes writing code, verifying programmed data, and erasing the device's memory.
Explains how to enable code protection features for the PICmicro MCU.
Explains the signals and requirements for In-Circuit Serial Programming (ICSP) with PICmicro microcontrollers.
Discusses isolating the VPP/MCLR/PORT pin from application circuitry to handle VPP voltage.
Covers isolating ICSPCLK/PGC and ICSPDAT/PGD pins to prevent interference from application circuitry.
Explains VDD powering options and bulk erase voltage requirements, noting potential conflicts.
Provides advice on minimizing signal path length and cable length for successful ICSP programming.
Introduces in-circuit debugging with PICkit 2 and its interaction with MPLAB IDE.
Explains selecting the target device and the PICkit 2 as the debugging tool within MPLAB IDE.
Covers updating PICkit 2 firmware and configuring debug settings, including auto-connection.
Guides through creating a new project, selecting tools, and building the application code.
Explains loading code, setting debug options, using breakpoints, and analyzing program execution.
Demonstrates fixing a bug, reprogramming, and preparing for stand-alone application programming.
Describes how to update the PICkit 2 Microcontroller Programmer's operating system firmware.
Guides on downloading the latest OS, selecting it in the software, and completing the update.
Describes common problems associated with the PICkit 2 programmer and how to resolve them.
Troubleshoots messages like 'Insert Device' and 'USB Hub Current Limit Exceeded'.
Explains driver installation for Windows and compatibility with older OS versions.
Addresses issues where Read or Verify returns zeros, often due to code protection.
Provides an introduction to the PICkit 2 Microcontroller Programmer schematic diagrams.
To Next Page
