2016 Microchip Technology Inc. DS50002466A-page 63
SS Enable default services
ST Set connection parameters for central
SW Assign GPIO functions
Get Commands
G: Read any settings in configuration eFlash
GK Get current connection status
GNR Get remote device name
G<char> Get the stored settings for a corresponding set command.
Action Commands
+ Echo
$$$ Get into Command mode
--- Get into Data mode
! Enter/exit Remote Command mode
@ Read analog port
|I Read digital port
|O Set digital port
[ PWM control
& Static private address assignment
&C Clear random address and use MAC address
&R Create and use a resolvable random address
A Start advertisement
B Start bonding process
C Connect to peer device as central
D Display RN4870 critical information
F Start scanning as central
I Start UART Transparent with RN4020 and RN4677/4678
IA Set advertisement content immediately
IB Set beacon content immediately
IS Set scan response content immediately
JA Add device into white list
JB Add all bonded device into white list
JC Clear white list
JD Display all devices in white list
K,1 Disconnect
M Read RSSI value of connected device
NA Set advertisement content permanently
NB Set beacon content permanently
NS Set scan response content permanently
O Shut down device
R,1 Reset
T Change connection parameters instantly
U Unbond device(s)
V Display firmware version
X Stop scan
Y Stop advertisement
TABLE B-2: COMMAND SUMMARY QUICK REFERENCE (CONTINUED)
ASCII Command Description
To Next Page
Loading...
