www.md-best.com
All Rights Reserved
Nabi User Manual
Beam Height 8.5 mm
Absorbance Range 0.002 – 2.0 Abs.
Measurement Time 3 sec
Cuvette Specification
• Due to fixed modules and immovable parts, internal maintenance is not needed.
Clean the exterior with a clean and dry wipe when there is a spill or contamination.
• DO NOT try to disassemble the instrument in any situation.
• Use an electric supply that conforms to industry standards.
• Place the instrument in a clean environment and away from other devices that
vibrate. (e.g. centrifuges)
• Test the general functions of the device – check buttons and the power switch.
• Confirm that the mechanical components are in good condition.
• Make sure accessories, cables, and positions are clean and intact.
• Calibration and update from the manufacturer is possible.
Maintenance
7
1. System Introduction
To Next Page
Loading...