microHAM © 2010 All rights reserved
DEVICE CONFIGURATION TABS
There are twelve (12) tabs for configuring MK2R. Each tab controls part of MK2R's functions. Except for
CW Messages, FSK Messages and Functions tabs, any change is applied immediately to MK2R.
●
Ports: assign virtual ports to the MK2R for use by applications
●
Audio Switching: configures microphone and sound card audio routing based on operator
preference, application sound card handling and operating mode
●
Audio Mixer: sets sound card or CODEC levels.
NOTE: The Audio Mixer is not available under Windows Vista or 7. Those operating systems do not
permit an application like Router overall control of the sound device.
●
PTT: configures T/R keying, keying sequencer and foot switch functions
●
CW/WinKey: configures the internal CW keyer
●
CW Messages: enter/store internal CW message memories
●
FSK Messages: enter/store internal FSK message memories
●
DVK: configure and control the level of Router's voice keyer
●
Keyboard: configure operation of PS/2 keyboard or keypad
●
SO2R: select source of focus control and other SO2R operating features.
●
ACC: configure the accessory port
●
Functions: configure headphone switching, audio routing for recording and digital operation.
26
To Next Page
Loading...
Need help?
General