Name: microHAM MK2R
Brand: microHAM
Rating: 4 (1 reviews)

To Next Page

To Previous Page

●

ACC output control: These commands control 16 bits represented by the 4-bit outputs of the ACC

port. The 4-bit outputs must be configured for “Protocol Control” on the ACC tab. Current firmware

treats the 4 four bits as a HEX representation (0-F) of a 1:16 decoder connected to the port. Only

one output may be active.

This command sets the output using a binary mask.

AM1xxxxxxxxxxxxxxxx<CR> SetAccOutputs(R1, outputs)

AM2xxxxxxxxxxxxxxxx<CR> SetAccOutputs(R2, outputs)

This command sets the output by decimal value.

AS1dd<CR> SetAccOutputSelection(R1, selection)

AS2dd<CR> SetAccOutputSelection(R2, selection)

●

Function control: This command selects Function 1 – 8

SAs<CR> ApplyScenario(scenarioIndex)

●

DVK, CW and FSK messages: These commands control playing and recording of messages. The

current operating mode (determined from the radio or Router if the radio is not CAT capable) will be

used to determine if Voice, CW or FSK messages will be played/recorded.

Abort::

This command aborts the current message and clears message queue.

MA<CR> AbortMessage()

Playback:

This command starts message playback – index is 1 to 9

MPm<CR> PlayMessage(msgIndex)

This command starts message playback in a loop – index is 1 to 9, interval is 0 to 9 seconds.

MPImi<CR> PlayMessagePeriodically(msgIndex, interval)

Record:

This command starts message recording – index is 1 to 9

MRm<CR> StartMessageRecording(msgIndex)

This command stops message recording.

MRS<CR> StopMessageRecording()

DVK Message Bank Select:

This command selects voice message bank – applies only to DVK.

MBname<CR> SetMessageBank(msgName)

microHAM MK2R User Manual

Other manuals for microHAM MK2R