1
This 3-in-1 jig serves as a tall fence, a jointing sled, and a tapering jig, all made possible by the
MATCHFIT System. When secured with Dovetail Clamps to a table saw, router table, or
bandsaw fence, it provides added support to cut material on its edge. Laid flat on the table
saw top, you can clamp warped or live edge material to it and safely cut a straight edge,
running the sled along the fence. By adding simple stops with Dovetail Hardware, you can set
the material at an angle and make safe, repeatable taper cuts.
(A)
(B)
(C)
(Z1)
- (1) 10” wide, 3/4” thick plywood, cut to the length
of your table saw fence -
*
void-free recommended
- (2) 2” wide x 6” long x 1/2” thick plywood blocks
To Next Page
Loading...
