EasyManua.ls Logo

microjig MATCHFIT - Instructions; Cut Stock to Size; Route Relief Grooves

microjig MATCHFIT
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10”
STEP 2 - ROUTE RELIEF GROOVES
2
On the table saw, cut a sheet of 3/4” thick plywood 10” wide x the length of your
table saw’s rip fence.
On the router table, set a 1/4” diameter straight or spiral router bit to a cutting
depth of 11/32”. Set the fence to 2” and route relief grooves along both long sides.
microjig MATCHFIT - Instructions; Cut Stock to Size; Route Relief Grooves