D) Measurement sequence
• With the full measurement cycles, the total measurement time remains less
than 3 minutes, compared to a single measurement time of 1.5 minute.
• Single results are not displayed.
• Due to the «Data Analysis» result, a 4th measurement may be applied.
3. The various components of the blood-pressure monitor
The illustration shows the blood-pressure monitor, consisting of:
Wrist cuff Type WC1 13.5-19.5 cm, for wrist circumference of 13.5 to 19.5 cm
4. Putting the blood-pressure monitor into operation
4.1. Inserting the batteries
After you have unpacked your device, first insert the batteries. The battery
compartment is located on the left lateral side of the device (see illustration).
7
Time Button
Memory Button
0/I Button
Wrist cuff
LCD Display
Battery
Cover
Mode selection switch
PC Connection
To Next Page
Loading...
