19
Other possible malfunctions and their elimination
If problems occur when using the device, the following points should be
checked and if necessary, the corresponding measures are to be taken:
Malfunction Remedy
The display remains empty when
the instrument is switched on
although the batteries are in
place.
The device frequently fails to
measure the blood pressure
values, or the values measured
are too low (too high).
Every measurement produce
different value although the
instrument functions normally and
the values displayed are normal.
Blood pressure values measured
differ from those measured by
the doctor.
☞ FURTHER INFORMATION
The level of blood-pressure is subject to fluctuations even with healthy
people. Important thereby is, that comparable measurements always require
the same conditions (Quiet conditions)!
If you have any questions regarding the use of this blood pressure monitor,
please ask your dealer or pharmacist for the Microlife Service representative
in your country. The Microlife Service Team will be happy to help you. Never
attempt to repair the instrument yourself!
Any unauthorized opening of the instrument invalidates all guarantee claims!
1. Check batteries for correct polarity and
if necessary insert correctly .
2. If the display is unusual, re-insert the
batteries or exchange them.
1. Check the positioning of the cuff.
2. Measure the blood pressure again in
peace and quiet under observance of
the details made under point 5.
1. Please read the following information
and the points listed under «Common
sources of error». Repeat the
measurement.
1. Record the daily development of the
values and consult your doctor.
To Next Page
Loading...
Need help?
General
