b) If you want to take a Single measure-
ment, position the slide switch to the left.
In this mode there is only one measure-
ment cycle.
c) Once you’ve selected the correct user,
and measurement mode you can press
the ON/OFF button to begin. After press-
ing the ON/OFF button the pump begins
to inflate the cuff. In the display, the
increasing cuff-pressure is continually
displayed.
d) After reaching the inflation pressure, the
pump stops and the pressure slowly falls.
The cuff pressure (large characters) is dis-
played during the measurement. When
the device has detected the pulse, the
heart symbol in the display begins to
blink and a beep tone is audible for every
pulse beat.
e) When the measurement has been con-
cluded, a long beep tone sounds. The
measured systolic and diastolic blood
pressure values as well as the frequency
are now displayed. (Pulse=number of
heartbeats each minute) Example (Fig.):
Systolic 118, Diastolic 73, Pulse 75. The
measurement results are displayed until
you switch the device off. If no button is
pressed for 5 minutes, the device switch-
es off automatically to save the batteries.
14
To Next Page
Loading...
