5.6. Memory – storage and recall of the measurements
This blood pressure monitor automatically stores the last 30 measure-
ments values for each user. By pressing the MEMORY button, average
of existing memory readings displayed first with an “A” and (MR) at
the lower left. Press MEMORY button again, the last measurement
(MR30) as well as the previous 29 measurements (MR29, MR28,
…..MR1) can be displayed one after the other. Data obtained in
Average Mode are indicated by a MAM symbol.
☞ Further
Information
When the unit is in Average Mode, time between measurements is
carefully controlled to ensure accuracy. If you take successive mea-
surements when the unit is in the single measurement mode wait for
several minutes in a relaxed position before you repeat a measure-
ment. Make sure all measurements are taken in a seated position.
5.7. Memory-recall of 3 intermittent average results
The blood pressure monitor can display the 3 intermittent average
results of the last stored memory. By pressing the MEMORY button at
least 3 seconds, the LCD will show icon first with one short
16
To Next Page
Loading...
Need help?
General
