Need help?Do you have a question about the Micromeritics AutoPore V Series and is the answer not in the manual?
General| Measurement Principle | Mercury Intrusion Porosimetry |
|---|---|
| Number of high-pressure stations | 1 |
| Pore Diameter Range | 360 μm to 0.003 μm |
| Intrusion Volume Accuracy | ±0.1% of full scale |
| Intrusion Volume Reproducibility | ±0.5% |
| Operating Temperature | 15 °C to 35 °C |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Accuracy | ±0.1% of full scale |
| Repeatability | ±0.5% |
Lists the components included in the Penetrometer Closure Kit, such as seals, nuts, tools, and wrenches.
Step-by-step instructions for applying grease, seating the seal, and tightening the penetrometer nut.
Procedure for removing the penetrometer nut using the specialized wrench if it is too tight.
To Next Page