Midas PRO6 Quick Reference Guide

42 Chapter 6: Basic Operation
PRO6 Control Centre
Quick Reference Guide
>> To select the mix bus mode
1 Select the mix bus (see “To select a mix bus” on page 22).
2 Press the quick access button
(adjacent to the filters section)
to assign the mix overview to
the channel strip. For example,
the aux send overview for
AuxS1.
3 Click within one of the sections (for example, dir in) to open
the mix processing area in the channel strip.
4 Press MODE repeatedly to scroll through the mix modes
(mix, group and mix minus) to select the one you want.
Group mode is fader only with no pre-fader, and mix minus
allows mute only with all buses being initially muted. Stereo
mix mode—with mix selected and LINK button on—is only
accessed from the odd numbered output channel of the
linked pair. In stereo mix mode the top control knob
becomes pan adjust and the bottom one adjusts level.
>> To set up a mono aux
mix
1 Making sure that the mix bus is not linked, select mix (see “To
select the mix bus mode” on page 42).
2 Select the input channel (see “Selecting channels, mix buses and
groups” on page 21).
3 At the GUI, click within the appropriate sends section (aux or
matrices) in the overview display (see Figure 10 on page 41) to
open its processing area.

Midas PRO6 Specifications

General

Brand	Midas
Model	PRO6
Category	Recording Equipment
Language	English