Busses and Routing
Auxiliary Sends Typical Configuration
When determining how many mix busses you wish to use for auxiliary sends, you may wish to consider the
following. We've also provided some recommendations on how to configure each send, depending on its
application.
Artist Monitor Sends Pre (Post EQ) The level in the monitor stays constant so that the
engineer can change the FOH level without affecting the
performer.
Effects Sends Post The level sent to the effects is proportional to the level on
the fader so the balance between wet (processed) and dry
(un-processed) sound stays the same even when the
channel level is changed.
Multitrack Recording Pre (Pre-EQ) The recording is made at constant level without EQ
or Monitors from FOH so that these changes can be set in post-production when
more time, and a better listening environment are available.
(You can also use the channel insert send as a Direct Out for
this application but note that the output will be at unity).
Application Pre/Post Fade Reason
Operators Manual - Page 33
Setting Up The SienaSetting Up The Siena
To Next Page
Loading...
Need help?
General
