Fitting the appliance door
Reattach the appliance door in the opposite sequence to removal.
1. When attaching the appliance door, ensure that both hinges are
placed right onto the installing holes of the front panel of the cavity.
Ensure that the hinges are inserted into the correct position. You
must be able to insert them easily and without resistance. If you
can feel any resistance, check that the hinges are inserted into the
holes right.
2. Open the appliance door fully. While opening the appliance door ,
you can make another check if the hinges areonto the right position.
If you make the fitting wrong, you will not be able to make the
appliance door fully opened.Fold both locking levers closed again.
3. Close the cooking compartment door. By the same time , we warmly
recommend you to check one more time, if the door is onto the
right position and if the ventilation slots are not half-sealed .
Removing the door cover
The plastic inlay in the door cover may become discolored. To carry
out thorough cleaning, you can remove the cover.
Remove the appliance door like instructed above.
1. Press on the right and left side of the cover.
2. Remove the cover.
3. After removing the door cover , that rest parts of the appliance
door can be easily taken off so that you can go on with the cleaning.
When the cleaning of the appliance door has finished , put the cover
back in place and press on it until it clicks audibly into place.
4. Fitting the appliance door and close it.
▲
▲
To Next Page
