Change the power cord (only for some models)
Position A show the terminal box position on the back of the back
outer case and it’s closed.
Steps: a. cut off the power, use small flat screwdriver to open two
snap 1，2.
b. use Phillips crewdriver to take off screws 3，4, 5 and 6.
c. change the new power cord ,fix the yellow/green wire on 3，
brother wire on 4，blue wire on 5.
d. twist screw 6 closed the terminal box cover finish the
changing.
Caution!
While the appliance door is well installed, the door cover can also be
taken off, by this time.
1. Removing the door cover means to set the inner glass of the
appliance door free, the glass can be easily moved and cause
damage or injury.
2. As removing the door cover and inner glass means to reduce the
overall weight of the appliance door. The hinges can be easier to be
moved when closing the door and you may be trapped. Keep your
hands away from the hinges.
Because of the 2 points above, we strongly recommend you not to
remove the door cover unless the appliance door removed. Damage
caused by incorrect operation is not covered under warranty.
terminal boxback outer case
A
power cord
brown {L}
blue {N}
yellow/green
21
6
3
5
4
▲
▲
To Next Page
Loading...
