Midea G06 User Manual

2 FACTORY PATTEN DETECTION
7
2.1 Service mode
Before entering into service mode, make sure no water remains in the inner drum, if not,
select drain only program to drain them out.
Turn on the machine and take turns [K2] [K4] [K2] [K4] buttons in 30s.
Press [K1] or [K2] to select test program. Press [K6] button to confirm your selection
and start the selected test. If you want to go back to test selection interface, press the
[K6] button to cancel previous selection.
LED
Display
Check
Target
Check Method Check Item
t01
Version
switchover
1. Press [K6] button
2. Press [K2] to change version
3. Press [K1] button continuously for
3s to confirm your change
LED displays“0xx”
x means current
version
t02
Error code
checking
1. Press [K6] button
2. Press [K1] to show the last code and press
[K2] to show the next code
3. Press [K2] and [K3] button at the same
time continuously for 3s, after hearing the
beep, all the error codes records deleted,
LED displays E00.
LED displays
“Err”
t03
Version
information
checking
1. Press [K6] button Enter into service mode,
LED displays “cod”.
2. Press [K6], LED displays project number.
3. Press [K1] button, LED displays version
number
LED displays version
number
K1 K2 K3 K4
K5
K6

Midea G06 Specifications

General

Brand	Midea
Model	G06
Category	Washer
Language	English