16 17
www.freedomhp.co.uk 02380 274 833 | sales@freedomhp.co.uk
Unlock screen
If the icon is on the screen, the controller is locked.
The following page is displayed:
Press any key, the icon will flash. Long press the ‘’UNLOCK’’ key.
The icon will disappear, the interface can be controlled.
Setting the clock and date
• Press MENU, press 6 times to SERVICE INFO press OK
• Press
3 times to DISPLAY press OK
• Go to TIME press
then use and to set the time hours
and minutes, press OK
• Go to DATE press
then use and to set the day and
month, press OK
• Go to Buzzer press ON / OFF to silence the noise from the
controller.
• Press back a few times to get to the front screen
Starting the unit in heating mode
Press to highlight the left hand side of the controller this is the
heating side, press ON / OFF
The middle of the controller tells you what is happening now. In this
case heating (the sun) is on, so the thermostats are calling. The unit
will start the pump in 2 minutes and the compressor in 5 minutes.
Check the pipework is heating up and the header is getting warm.
MAKE SURE there is no hot water going to the cylinder.
Note if you try to change the water temperature or turn the heating
off a message shows. This unit is controlled from an external
run signal and operates using the water settings for weather
compensation you set earlier.
Starting the unit in hot water mode to
heat the cylinder
Go back to the front screen, press to highlight the right side of the
controller. This is the hot water setting.
When you highlight the DHW it tells you the DHW set temperature,
when it’s not highlighted it shows the current DHW tank
temperature. With it highlighted press ON / OFF the unit will start
heating the cylinder
Note how the middle of the controller is now showing the tap to
indicate its actually heating the tank.
Starting the unit Starting the unit
Turning on or off cooling/
heating mode is controlled by
the room thermostat.
Please turn on or off cooling/
heating mode by the room
thermostat.
CONFIRM
OK
To Next Page
Loading...
Need help?
General