23
Use of wire or copper wire may cause the unit to break down 
or cause a fire. 
It is not good for your health to expose your body to the 
air flow for a long time.
Do not insert fingers, rods or other objects into the air 
inlet or outlet.
When the fan is rotating at high speed, it will cause injury. 
Never use a flammable spray such as hair spray, 
lacqueror paint near the unit.
It may cause a fire. 
Never put any objects into the air inlet or outlet.
Objects touching the fan at high speed can be dangerous.
Do not dispose this product as unsorted 
municipal waste. Collection of such waste
 separately for special treatment is necessary.
Do not dispose of electrical appliances as unsorted 
municipal waste, use separate collection facilities.
Contact  you  local  government  for  information  regarding  the 
connection systems available.
If  electrical  appliances  are  disposed  of  in  landfills  or 
dumps,  hazardous  substances  can  leak  into  the 
groundeater and get  into  the  food  chain,  damaging your 
health and well-being.
To prevent refrigerant leak, contact your dealer. 
When  the  system  is  installed  and  runs  in  a  small  room,  it  is 
required to keep the concentration of the refrigerant, if by any 
chance coming out, below the limit. Otherwise, oxygen in the 
room may be affected, resulting in a serious accident. 
The  refrigerant  in  the  heat  pump  is  safe  and  normally 
does not leak. 
Ask your dealer for installation of the heat pump. 
Incomplete installation performed by yourself may result in a 
water leakage, electric shock, and fire. 
Ask your dealer for improvement, repair, and 
maintenance.
Incomplete improvement, repair, and maintenance may result 
in a water leakage, electric shock, and fire. 
In order to avoid electric shock, fire or injury, or if you 
detect any abnormality such as smell of fire, turn off the 
power supply and call your dealer for instructions.
Never let the indoor unit or the remote controller get wet.
It may cause an electric shock or a fire.
Never press the button of the remote controller with a 
hard, pointed object.
The remote controller may be damaged. 
Never replace a fuse with that of wrong rated current or 
other wires when a fuse blows out. 
Do not use the heat pump for other purposes. 
In order to avoid any quality deterioration, do not use the unit 
for cooling precision instruments, food, plants, animals or 
works of art. 
Before cleaning, be sure to stop the operation, turn the 
breaker off or pull out the supply cord. 
Otherwise, an electric shock and injury may result. 
In order to avoid electric shock or fire, make sure that an 
earth leak detector is installed.
Be sure the heat pump is grounded.
In order to avoid electric shock, make sure that the unit is 
grounded and that the earth wire is not connected to gas or 
If  the  refrigerant  leaks  in  the  room,  contact  with  a  fire  of  a 
burner, a heater or a cooker may result in a harmful gas.
Turn  off  any  combustible  heating  devices,  ventilate  the 
room,  and  contact  the  dealer  where  you  purchased  the 
unit.
Do not use the heat pump until a service person confirms that 
the portion where the refrigerant leaks is repaired. 
water pipe, lightning conductor or telephone earth wire.
In order to avoid injury, do not remove the fan guard of 
the outdoor unit.
Do not operate the heat pump with a wet hand. 
An electric shock may happen. 
Do not touch the heat exchanger fins. 
These fins are sharp and could result in cutting injuries.
Do not place items which might be damaged by moisture 
under the indoor unit. 
Condensation may form if the humidity is above 80%, the 
drain outlet is blocked or the filter is polluted. 
After a long use, check the unit stand and fitting for 
damage.
If damaged, the unit may fall and result in injury.
To avoid oxygen deficiency, ventilate the room 
sufficiently if equipment with burner is used together 
with the heat pump.
Arrange the drain hose to ensure smooth drainage.
Incomplete drainage may cause wetting of the building, 
furniture etc.
Never touch the internal parts of the controller.
Do not remove the front panel. Some parts inside are 
dangerous to touch, and a machine trouble may happen.
Never do the maintenances work by yourself.
Please contact your local dealer to do the maintenances 
work.
WARNING
CAUTION