8
INSTALLATION INSTRUCTIONS
REMOVE PACKAGING
•
Remove packaging, foam cushions, and bottom cardboard.
• Open the washer door and take out the accessories.
• Use of washer with the foam cushion is strictly prohibited.
Foam
Cushion
Base
The height of the drain hose (A) should be betw een ~34 to
40”.Its diameter (B) should not be less than 1.20”, and its
flow capacity should not be less than 40 L/Min.
FOR U PPE R D R AIN SYSTEM ONLY
34~40''
PLACEMENT OF UPPER WATER DRAIN HOSE
Before starting the w asher, users should properly hang the drain
pipe ~34 to 40”above the floor.
INSTALLATION OF WATER INLET HOSE
• Place the water inlet hose screw onto the tap.
Water inlet hose
Clamping nut
ONLY FOR WATER INLET HOSE
WITH DOUBLE THREADED SCREW
• Tightly screw the other end of the hose to the
water inlet valve using the rubber seal ring
inside.
NOTE:
When tightening the clamping nut, evenly
apply force and avoid twisting the water inlet valve
to prevent breakage of the water inlet valve joint.
To Next Page
Loading...
