Midea MAP06R1BWT - Installation Instructions

Preparation
front
control panel
remote signal receptor
horizontal louver control
lever(adjust manually)
vertical louver control
lever(adjust manually)
panel
Caster
NOTE: PHA can not be
adjusted.
NOTE: PHA can not be
adjusted.
rear
handle
(both sides)
bottom tray
drain outlet
air filter
upper air intake
air outlet
lower air intake
drain outlet
DESIGN NOTICE
NOTE:
All the illustrations in the manual are for explanation purpose only. Your machine may
be slightly different.
The actual shape shall prevail. The unit can be controlled by the unit control panel
alone or with the remote controller. This manual does not include Remote Controller
Operations, see the <<Remote Controller Instruction>> packed with the unit for
details.
In order to ensure the optimal performance of our products, the design speci cations
of the unit and remote control are subject to change without prior notice.
INSTALLATION INSTRUCTIONS
Installation
Instructions
12
This feature can be activated from the remote control
ONLY. To activate SLEEP feature, the set temperature
will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then
increase(cooling) or decrease(heating) by another 1°C
/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
thermostat allowing for the precise temperature
control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control towards the
unit and press the Follow Me/Temp Sensing button.
The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing
button again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7 minutes interval,
the unit will exit the Follow Me/Temp Sensing mode.