Midea MAP06R1BWT - Remote Control Instructions

Remote Control
Instructions
24
This feature can be activated from the remote control
ONLY. To activate SLEEP feature, the set temperature
will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then
increase(cooling) or decrease(heating) by another 1°C
/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
thermostat allowing for the precise temperature
control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control towards the
unit and press the Follow Me/Temp Sensing button.
The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing
button again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7 minutes interval,
the unit will exit the Follow Me/Temp Sensing mode.
INGESTION HAZARD - Contains small batteries, Keep out of reach of small children. If swallowed, seek
immediate medical attention.
Remote Control Specifications
REMOTE CONTROL INSTRUCTIONS
CAUTION
Model
Rated voltage
Signal receiving range
Environment
RG57H1(B)/BGCUEU1-M
3.0 V (dry batteries R03/LR03×2)
8 m
-5
O
C~60
O
C (23
O
F~140
O
F)