50cm
50cm
19.7inch
50cm
19.7inch
19.7inch
50cm
19.7 inch
Ambient Temperature Range For Unit Operating
Exhaust Hose Installation
The exhaust hose and adaptor must be installed or removed in accordance with the
usage mode. For COOL,HEAT(heat pump type) or AUTO mode must be installed
exhaust hose. For FAN, DRY or HEAT(electrical heat type) mode must be removed
exhaust hose.
Choosing The Right Location
Recommend Installation
Installation
Instructions
13
MODE Temperature Range MODE Temperature Range
Cool 17-35°C (62-95°F)
Dry
Heat(pump heat mode)
Heat(electrical heat mode) 13-35°C (55-95°F)
5-30°C (41-86°F)
30°C (86°F)
-
-
-
-
Your installation location should meet the following require-
ments:
Make sure that you install your unit on an even surface to mini-
mize noise and vibration.
The unit must be installed near a grounded plug, and the Col-
lection Tray Drain (found on the back of the unit) must be
accessible.
The unit should be located at least 50cm (19.7”) from the
nearest wall to ensure proper air conditioning. The horizontal
louver blade should be at least 50cm (19.7”) away from obsta-
cles.
DO NOT cover the Intakes, Outlets or Remote Signal Receptor
of the unit, as this could cause damage to the unit.
This feature can be activated from the remote control
ONLY. To activate SLEEP feature, the set temperature
will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then
increase(cooling) or decrease(heating) by another 1°C
/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
thermostat allowing for the precise temperature
control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control towards the
unit and press the Follow Me/Temp Sensing button.
The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing
button again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7 minutes interval,
the unit will exit the Follow Me/Temp Sensing mode.
To Next Page
Loading...
