The energy rating and noise information for this unit is based on the standard installa-
tion using an un-extended exhaust duct without window slider adaptor (as shown in
the Installation section of this manual). At the same time, the unit must be operate on
the COOL MODE and HIGH FAN SPEED by remote controller.
The unit with 3 meters extended exhaust duct is running by using 2 exhaust ducts(Di-
ameter:150mm, Length:1.5m + Diameter: 130mm, Length: 1.5m) .The Energy rating and
noise information for unit with 3 meters extended exhaust duct is not assessed.(For
some models)
NOTE：
We recommend that operating the unit at room temperature below 35°C . Since there
is a risk that the unit with 3 meters extended exhaust duct would not work at room
temperature above 35°C under some extreme conditions, such as the lower air intake
be blocked for 50%.
Installation
Instructions
14
Energy Rating Information
Because of a new federal test procedure for Portable Air Conditioners, you may
notice that the cooling capacity claims on portable air conditioner packaging are
significantly lower than that of models produced prior to 2017.
This is due to changes in the test procedure, not to the portable air conditioners them-
selves.
What should I look for first when purchasing a portable air conditioner?
The right air conditioner helps you cool a room efficiently. An undersized unit won't
cool adequately while one that's too large will not remove enough humidity, leaving
the air feeling damp. To find the proper air conditioner, determine the square footage
of the room you want to cool by multiplying the room length by its width. You also
need to know the air conditioner's BTU (British Thermal Unit) rating, which indicates
the amount of heat it can remove from a room. A higher number means more cooling
power for a larger room. (Be sure you are comparing only newer models to each
other- older models may appear to have a higher capacity, but are actually the same).
Be sure to “size up” if your portable air conditioner will be placed in a very sunny
room, in a kitchen, or in a room with high ceilings. After you’ve found the right cooling
capacity or your room, you can look at other features.
Why is the cooling capacity lower on newer models than on older units?
Federal regulations require manufacturers to calculate cooling capacity based on a
specific test procedure, which was changed just this year. Models manufactured
before 2017 were tested under a different procedure and cooling capacity is mea-
sured differently than in prior years’models. So, while the BTUs may be lower, the
actual cooling capacity of the air conditioners has not changed.
What is SACC ?
SACC is the representative value of Seasonally Adjusted Cooling Capacity, in Btu/h,
as determined in accordance with the DOE test procedure at title 10 Code of Federal
Regulations (CFR) 430, subpart B, appendix CC and applicable sampling plans.
How to Stay Cool with a New Portable Air Conditioner(For the
models comply with the requirements of Department Of Energy in
US)
This feature can be activated from the remote control
ONLY. To activate SLEEP feature, the set temperature
will increase(cooling) or decrease(heating) by 1°C/2°F
(or 1°F) in 30 minutes. The set temperature will then
increase(cooling) or decrease(heating) by another 1°C
/2°F (or 1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
thermostat allowing for the precise temperature
control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control towards the
unit and press the Follow Me/Temp Sensing button.
The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing
button again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7 minutes interval,
the unit will exit the Follow Me/Temp Sensing mode.
To Next Page
Loading...
