Active clean function( ) (some units) :
The FOLLOW ME function enables the
remote control to measure the temperature
at its current location and send this signal to
theair conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
The SLEEP function is used to decrease energy
use while you sleep (and don’t need the same
temperature settings to stay comfortable).
This function can only be activated via remote
control.
For the detail, see sleep operation in
“USER’S MANUAL”
Note:
The SLEEP function is not available in
FAN or DRY mode.
Sleep function( ) :
Follow me function ( ):
NOTE:
Press and hold Boost button for seven
seconds to start/stop memory feature of
Follow Me function.
If the memory feature is stopped,“ OF ”
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the
mode or power failure will not cancel the
Follow me function.
If the memory feature is activated,“ On ”
displays for 3 seconds on the screen.
AP function( )(some units) :
Choose AP mode to do wireless network
configuration. For some units, it doesn’t
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
FRESH function( ) (some units) :
When the FRESH function is initiated, the ion
generator is energized and will help to purify the
air in the room.
The Active Clean Technology washes away
dust, mold, and grease that may cause odors
when it adheres to the heat exchanger by
automatically freezing and then rapidly thawing
the frost.
When this function is turned on, the indoor unit
display window appears “CL”, after 20 to 45
minutes, the unit will turn o automatically and
cancel CLEAN function.
5
To Next Page