Midea MGBT-F25W/DN1

R410a tropical air-cooled scroll chiller unit 60Hz MCAC-ATSM-2014-09
174 Wired Controller
3.6 NetWork variables of setting main controller
NO Name
Name
2:4800bps
Initial value=2
Address
Type
nciUARTBaud SNVT_count
SNVT_count
SNVT_count
nciType
NciCtrl_Addr
Network
variable name
Network
variable type
Data definition Descriptions
1
2
3
Gateway type, need to be set as the actual condition.
The initial value is 0
Used for setting the baud rate of Rs485 port, and the
gateway is used 4800 baud rate.
The value is fixed to be 2.
The gateway address of the Air-cooled Modular unit
system. “Address” must be set the corresponding
value, as displayed in Table A. The initial value is 240.
0：G/H type
air-cooled scroll
chiller
1：V type air-cooled
scroll chiller
240,241...255
Initial value=240
nciCtrl_Addr
255
0
254
1
253
2
252
3
251
4
250
5
249
6
248
7
247
8
246
9
245
10
244
11
243
12
242
13
241
14
240
15
Corresponding address of wired controller
Caution
First power on, it needs to set the gateway property as the actual conditioner, then connect the gateway which
has been set to the Air-cooled Modular system.
* In a Air-cooled Modular system, there are wired controller and gateway, the address which the address
variable of the gateway (nciCtrl_Addr) corresponds to the address of wired controller must be larger than all
the wired controller addresses (As displayed in Table A).
Gateway address setting example: One Air-cooled Modular system, there are two wired controllers, the
addresses are 0, 13, and as displayed in Table A, the gateway must be set to 241 or 240, for only 241 and
240 corresponding addresses of wired controller are larger than the wired controller address 13.
The network variables which are assigned to the Air-cooled Modular system:
The network variable of Air-cooled Modular system: 4 input network variables, used for setting; 8 output
network variables, used for query. As the following figure: