LET’S COMMUNICATE!
To t
urn radio on/off
Hold the (MODE) [4] button down for 3 seconds. The radio beeps 3 times with
different tones (beeps may be inhibited). The LCD [1] displays a “self-test” message
for 1 second, it will then show the last channel selected.
Display illumination
Press one of these buttons (MODE or up / down) to activate display illumination for
approximately 5 seconds.
Keypad lock
Press and hold the SCAN [3] button for longer than 3 seconds. The key icon is
displayed for 3 seconds to confirm the lock has been activated. PTT (transmit) button
will still be active.
Repeat the same procedure to unlock the keypad.
To adjust the volume level, push UP/DOWN [7] buttons until the required level is
obtained.
Channel selection
Press the MODE [4] button once and then the UP [6] / DOWN [7] controls to select
one of the 8 channels. To confirm the selection, push PTT [7] or wait for
approximately 5 seconds.
Attention!
- PMR446 channels: P1, P2, etc.
- LPD channels: 1,2,3, etc.
PMR 446 channels for free use in Europe, except in Belgium, Finland,
Switzerland, Luxembourg *:
PMR 446 channel Frequency (MHz)
P1 446.00625
P2 446.01875
P3 446.03125
P4 446.04375
P5 446.05625
P6 446.06875
P7 446.08125
P8 446.09375
*Up to now, the above mentioned countries do not allow at all the use of radios on
their territory which have a switching facility between PMR 446 and LPD.
The other European countries, which are not in the list of the LPD countries, allow
the use of this radio under the condition, that only the PMR 446 frequencies will be
selected.
To Next Page
Loading...
