Midland 777 - Power Management; Keypad Beep; Call Tone; Vibracall

HI AND LOW POWER
To extend the battery life, you can select the low power mode.
To activate the low power:
• turn on the unit
• press the MODE [4] button 4 times, until the display shows “Pr hi”.
• select the low power by pushing the “▲” o “▼”[7] buttons.
• confirm by pushing the PTT [8] or simply wait 5 seconds.
With this procedure, the power is reduced of 10 times approx.
KEYPAD BEEP
To deactivate the keypad beep at the pressure of any key, follow these steps:
• Turn on your MIDLAND 777.
• press the MODE [4] button 5 times, until the display shows “bP on”.
• Push “▲” o “▼”[7] until “bP of” appears on the display.
• confirm by pushing the PTT [8] or simply wait 5 seconds.
With this procedure, you won’t hear any beep at the pressure of any button.
CALL TONE
MIDLAND 777 can send 3 different call tones (melodies). To send this audio signal to
other users, press rapidly the PTT [8] key twice.
To select the call tones:
• turn on the transceiver
• push MODE [4] 7 times, until the display shows “CA 1”.
• push “▲” or “▼”[7]: you will hear the 3 pre-set melodies.
• confirm by pushing the PTT [8] key or wait 5 seconds.
Now, each time your MIDLAND 777 will send out a tone call, it will beep with the
selected melody. To disable this feature, set “of” on the display.
VibraCall
MIDLAND 777 is equipped with the function “VibraCall”, which provides a silent alert
for incoming tone calls.
To activate it, follow these steps:
1. turn on the unit.
2. press the MODE [4 key 8 times, until the display shows the VibraCall Icon
3. pushing “▲” or “▼”: you will enable/disable this feature.
4. confirm by pushing the PTT [8] key or wait 5 seconds.
Note: A VibraCall Alarm can only be received by another MIDLAND 777, and not by
any other radio model. Also in case that the distant party should have selected one of
the 3 melodies for calling, such alarms will be detected as Vibra Call, if you should
have selected VibraCall in Your receiving radio.