Midland ALAN 121 - Technical Specifications

E N G L I S H
6
TECHNICAL SPECIFICATIONS
GENERAL
Channels ................................................................. 40 FM (see the frequency band chart)
Frequency Range ..............................................................................25.615 to 30.105 MHz
Frequency Control ......................................................................................................... PLL
Operating Temperature Range ..........................................................................-10°/+55° C
DC input voltage ......................................................................................... 13.8V DC ±15%
Duty cycle ...........................................................................................5/5/90 (1 hour of use)
Size........................................................................................... 165 (L)x38 (H)x123 (D) mm
Weight ................................................................................................................... 0,820 Kg
RECEIVER
Receiving system ........................................................... dual conversion superheterodyne
Intermediate frequency .................................................I° IF: 10.695 MHz • II° IF: 455 KHz
Sensitivity ........................................................................................< 1µV for 20 dB SINAD
Audio output power @10% THD .........................................................
Min.2.0 W @ 8 Ohm
Audio distortion ................................................................................less than 3% @ 1 KHz
Current drain at stand/by .......................................................................................... 200mA
TRANSMITTER
Output power. ............................................................................................ 4W @ 13.8V DC
Modulation .........................................................................................AM: from 85% to 95%
.........................................................................................................FM: 1,8 KHz ± 0,2 KHz
Current drain ................................................ 1100mA (Power position with no modulation)
A readily accessible disconnect device shall be incorporated in the installation wiring.
The disconnect device shall disconnect both poles simultaneously.
All specications are subject to change without notice.